2 files

Data on Hausner Ratio of Polyamide 12 (PA12) in Polymer Selective Laser Sintering

posted on 2023-07-31, 06:29 authored by Xi Guo, Brij M. Moudgil


The CSV file contains the raw Polyamide 12 (PA12) Hausner ratio data in Table 2. The measurement method was modified from ASTM C1444. The powder measurement container is a pre-weighted 100 ml graduated cylinder. In bulk density measurement, the powder was filled into the container along its side wall. The volume reading and the total weight were documented for bulk density calculation. After the bulk density measurement, the powder-filled container was placed on a Vortex-Genie 2 lab mixer for three minutes followed by 10 manual taps to condense the powder. The tapped powder volume was then documented for tapped density calculation. The Hausner ratio was then calculated based on bulk density and tapped density. 

Experimental conditions:
100 ml graduated cylinder
Vortex-Genie 2 lab mixer
Room temperature


I/UCRC: Proposal to Establish a Joint NSF I/UCR Center for Particulate Systems and Surfactants

Directorate for Engineering

Find out more...


Corresponding author email address



© 2023 The Author(s)